Technical Manual Covering the Construction of a PC System Essay

Technical Manual Covering the Construction of a PC System - strive Example1.Open up the vitrine by undoing the screws and removing the side panels.2.Insert the Power publish Unit (PSU) taking c are to line up cooling fan with case vent. Attach unwaveringly with supplied screws and ensure the three-pin AC power cable is free and ready to be connected to the motherboard.3.Carefully labor out the motherboard from its antistatic bag and match up the holes in the board to the holes on the case. Then add the charge plate stand-offs (supplied) to those holes. At this time, also make sure that the rear of the motherboard matches the bracket at rear of case. If not, remove case bracket and replace with compatible bracket which will have been supplied by motherboard manufacturer. Before fixing the motherboard to the case, it is easier to attach the CPU and fan assembly to the motherboard first.4.Installing the CPU and heatsink/fana.On the motherboard, raise the CPU (processor) retaining latch. b. exclude CPU from antistatic bag by its edges, place into processor socket and push retaining latch back into position.c.Add close to heatsink compound (dont skimp on the quality of this seemingly unimportant item. Buy the best) to the heat broadcaster on top of the chip. Some instructions suggest mounding compound in the centre of the heatsink. Follow whatever particular instructions come with your processor. The heatsink/fan assembly will sit on top of this.d.Because we are adding a regular Intel heatsink/fan unit, we need to align four pegs on the corners of the heatsink/fan assembly with holes in the motherboard.